Nostalgia Electrics Retro RSM-650 - Manual (Page 7)

ENGLISH 5
E. Pour
your selected
beverage directly into the unit
by means of the molded square
indention located on the top of
your RETRO VERTICAL
SLUSH MACHINE™. (Figure
H).
NOTE: Do not use the
slush maker to freeze
liquids without any
sugar (such as water)
as this may damage
the appliance. Water
will freeze very quickly
to the exterior of the
ice cylinder and could
damage the unit.
FIGURE H
DO NOT Fill beyond the MAX
line. (Approximately 1 Quart of
liquid).
F.
Allow the mixture to mix for
up to 25 minutes until you reach
the desired slush consistency.
FIGURE I
NOTE: You can
continually add ice to the
unit as you are creating
slush by dropping ice
into the slush machine
using the open hole in
the lid. (
Figure I ). Do NOT
exceed filling the ice
cylinder 1-inch from the
top as there is a risk that
the slush mixture will
become contaminated
with salt.
If lid should pop off while machine
is mixing, turn on/off switch to
OFF, use spoon or spatula to
scrape any ice that may build up
on outside of cylinder, and
replace lid. (This will happen to
keep gears from stripping). Turn
on/off switch back to FREEZE
and continue mixing.
G. When mixture reaches desired consistency, place cup under spigot and
slide the on/off switch forward to DISPENSE. Turn the slush dispenser handle to
the right to dispense drink.
NOTE: Keep unit running until all slush
has been dispensed
. Be sure to turn handle back to CLOSE after filling
each cup.
NOTE: If slush gets too thick, or does not dispense well, add more liquid to the
mixing chamber opening.