Napco Security Technologies GEM-K1CA User Manual
Page 11
11
F I R E P R O T E C T I O N
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
Fire-Zone Alarm
If a fire is detected, “FIRE ALARM” will be displayed and the keypad sounder will pulse.
In addition, the "FIRE" icon will flash.
1.
If a fire is in progress, evacuate the premises immediately! If necessary, call the
Fire Department from an outside phone.
2.
Press the
C
button to silence the keypad sounder.
3.
If there is no evidence of a fire, enter your User Code and press
U
to turn off the
alarm.
4.
Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light
will be on.
After the alarm condition is corrected (thermostat cooled down; smoke cleared from
detector; etc.), pressing
C
again will reset the keypad within about 10 seconds.
NOTE: When the Fire Zone is reset, the FIRE icon on the left side of the display will go
out. If the FIRE icon is still displayed, the fire zone has not been properly reset. If you
cannot clear this condition by pressing
C
, call for service.
Fire-Zone Trouble
1.
If a problem in the fire-circuit is detected, “FIRE TROUBLE” will display and the
sounder will pulse to signal a malfunction. The "FIRE TBL" icon will display, and
the "SYS TBL" icon will flash.
2.
Press
C
to silence the sounder. Call for service immediately!
FIRE
F I R E A L A R M
FIRE TBL
SYS TBL
F I R E T R O U B L E