NetComm NP1100 - Manual (Page 4)

4 NP1100 10/100Mbps PCI Bus Fast Ethernet Card
YML567 Rev2
8. Connect the other end of the network cable into a port on your Ethernet hub.
9. Reconnect the power cable and turn on your computer.
10. You may need to follow Step 2: BIOS Configuration. If not, continue to Step 3:
Driver Installation and follow the section for your operating system to complete
installation of the PCI Network Adaptor.
NOTE: You may be asked for your original Windows® CD during the
installation process, please have it ready. If your computer
came with Windows® pre loaded the installation files may be
located in C:\windows\option\cabs folder.
Step 2: BIOS Configuration
Due to a fault in some Plug-n-Play BIOS programs, it happens occasionally that a newly
installed adapter is assigned an Interrupt Number which is already assigned to another
device.
In such a case, the conflict of Interrupt Number will cause faults in the behavior of both
devices. Then it is necessary to run the CMOS Setup utility, and manually assign a non-
conflicting Interrupt Number.