Nortel Networks NORSTAR VOICE MAIL 4.0 FAX P0886629 - Manual (Page 69)

Appendix B: Dialing Translation 69
P0886629 Issue 1.0 FAX Set Up and Operation Guide
Creating an Autoexec.bat file
The Autoexec.bat file is a file that contains commands a computer automatically
executes when it starts up. In the following steps you are creating a Autoexec.bat
file that automatically loads the Dialing Translation Table file into the proper
location on the Norstar Voice Mail system.
To create the Autoexec.bat file:
1. Open the text editor program you used to create the Dialing Translation Table
file.
2. Create a new document.
3. Type copy a:\dial.20 c:\st\dial.20
Note: This is the only text that should appear in the file.
4. Save the file as autoexec.bat
Note: The file must be named exactly as shown above. Do not save this file into
the root directory (C:\) of your computer or you will destroy the existing
Autoexec.bat file.
Loading the files onto the DOS system disk
To load the files onto the DOS system disk:
1. Insert the DOS system disk that you created earlier into the floppy disk drive
of your computer.
2. Use the Change Directory command (CD) to move to the directory where the
Dialing Translation Table file is stored.
3. Type copy dial.20 a:\dial.20 to load the Dialing Translation
Table file onto the DOS system disk.
4. Use the Change Directory command (CD) to move to the directory where the
Autoexec.bat file you created is stored.
5. Type copy autoexec.bat a:\autoexec.bat to load the
autoexec.bat file onto the DOS system disk.