Nortel Networks ALTEON OS BMD00009 - Manual (Page 24)

Alteon OS BBI Quick Guide
24 „ Configuring the Switch BMD00009, November 2007
5. Apply and save your changes using the toolbar commands.
Pending configuration changes (including deletions) do not take effect until you click the
Apply command.
Applied changes take effect on the switch immediately, but will be lost the next time the switch
is rebooted, unless the you click the Save command.
Using the BBI to Load Switch Software
You can use the Browser-Based Interface to load software onto the GbE Switch Module. The
software image to load can reside in one of the following locations:
„ FTP server
„ TFTP server
„
Local computer
After you log onto the BBI, perform the following steps to load a software image:
1. Click the Configure context tab in the Alteon OS toolbar:
2. In the Navigation Window, select System > Config/Image Control.