Nextel comm IR1200 - Manual (Page 45)

Verifying Installation
RFM-4200-5015 Rev1 37
Verifying Installation
In this chapter, you will learn how to verify that the installation of the iR1200
modem was successful.
This chapter includes:
Powering up the Modem
Vehicle Installation
Stationary Installation
Page 37
Page 37
Page 38
Communication Indicators Page 38
Powering Up the Modem
Once you have completed the installation of the modem’s hardware
components and connected all the power cables, power up the modem to ensure
that the installation was successful.
Powering Up – Vehicle Installation
The following table contains the steps for powering up the modem for a vehicle
installation:
1 Turn on the vehicle’s ignition.
2 The STATUS LED light will initially blink Red. This
indicates that the modem is searching for a signal within the
Nextel network.
3 A blinking Green light indicates that a signal has been found
and the modem was successful in making a connection.
4 The STATUS LED should blink Green within 3 minutes
from the time the vehicle’s ignition was turned ON.