National Instruments PXI-8184 - Manual (Page 24)

Chapter 2 Installation and Configuration
© National Instruments Corporation 2-11 NI PXI-8184/8185 User Manual
behavior due to an incorrect or inappropriate BIOS setting. Notice
that any nondefault settings such as boot order, passwords, and
keyboardless operation are restored to their factory defaults. This
may produce undesirable behavior, and in heavily customized cases,
may cause the controller to malfunction or fail to boot.
• Discard Changes—Any changes made to BIOS settings during this
session of the BIOS setup program are discarded. Unlike Exit
Discarding Changes, however, the BIOS setup continues to be active.
• Save Changes—Changes made to BIOS settings during this session
are committed to battery-backed System CMOS. The setup program
remains active, allowing further changes.
System CMOS
The NI PXI-8184/8185 contains a backed-up memory used to store
BIOS configuration information.
Complete the following steps to clear the CMOS contents.
1. Power off the chassis.
2. Remove the controller from the chassis.
3. Move the jumper on J1 from pins 1-2 to pins 2-3, as shown in
Figure 2-3.
4. Wait one second. Move the jumper back to pins 1-2.
5. Reinstall the controller in the chassis.
Caution Do not leave the jumper on pins 2-3. Doing so decreases battery life.