National Instruments PXI-8184 - Manual (Page 25)

Chapter 2 Installation and Configuration
NI PXI-8184/8185 User Manual 2-12 ni.com
Figure 2-3. Clearing the CMOS Contents (NI PXI-8185 Shown)
Note For clarity, the battery is not shown in Figure 2-3.
LabVIEW RT Configuration Switches
Note These switches are functional only if the controller supports LabVIEW RT.
Use the LabVIEW RT configuration switches to configure LabVIEW RT
if it is installed on the controller. If you are not using LabVIEW RT, these
switches should remain in the OFF position. The controller reads these
switches only after a system reset. You must reboot the controller for any
changes to take place.
1 Normal Operation (Default) 2 Clear CMOS Contents 3 Pin 1
1 2
3