Nortel Networks FastRad - Manual (Page 32)

22
FastRAD Installation Guide
Programming
Record
Complete the FastRAD Programming Record before you start
programming.
FastRAD Programming Record
Work Site: _______________________________________________________________
Address: ________________________ Telephone Number: __________________
________________________ Installation Date: __________________
________________________ Installer: __________________
Notes: _______________________________________________________________
GENERAL
System ID
Number
__________
Enter the System ID number. (Disable Admin if required.)
ALARM
Auto-
report Off ❑
On ❑
Choose if you want the FastRAD to report alarms. The default is
Off.
Report
Line
__________
Enter the line number. Enter a number between 001 and 999.
The default is 001.
Alarm
Number 1 __________ Enter the telephone number of the device where the FastRAD
reports alarms.
Alarm
Number 2 __________ Enter the telephone number of a second device where the
FastRAD reports alarms.
Retry
Delay
__________
Enter the number of minutes the FastRAD waits before it retries
to report an alarm. Enter a number between 1 and 99.
Number
of Retries
__________
Enter how many times a FastRAD tries to send an alarm after a
failed connection attempt. Enter a number between 0 and 9.
Alarm
Baud Low ❑
Medium ❑
High ❑
Choose the alarm baud number. The default is High.
Parity None ❑
Odd ❑
Even ❑
Choose which parity setting the FastRAD uses. The default is
None.
DATA
Auto-
answer Off ❑
On ❑
Choose if you want the FastRAD to answer incoming calls
(must be ON to allow remote, unassisted access). The default is
Off.
Answer
Line
__________
Enter the line number. An on-core KSU line is recommended.
Enter a number between 001 and 999. The default is 001.
855601 Book : 855601 Guide Page 22 Wednesday, October 29, 1997 4:06 PM