NordicTrack NTHK22490 - Manual (Page 6)

Assembly
Assembly requires two people. Set the hiker in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver .
Note: The underside of the hiker walking belt is coated with high-performance lubricant. During shipping, a small
amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con-
dition and does not affect hiker performance. If there is lubricant on top of the walking belt, simply wipe off the lu-
bricant with a soft cloth and a mild, non-abrasive cleaner.
6
1. Identify the right Upright (65), which has the Upright Wire
Harness (63) inside of it. Slide an Upright Collar (48) onto
the Upright.
63
48
65
1
2. While a second person holds the right Upright (65), con-
nect the Upright Wire Harness (63) to the Base Wire
Harness (97) and insert both Wire Harnesses into the
post on the Base (82). Make sure that the Upright (65) is
in the position shown in drawing 1. Slide the Upright onto
the post and align the indicated holes. Be careful not to
pinch the Wire Harnesses.
2
63 48
65
82
Holes
Holes
97
3. Slide the Upright Collar (48) to the position shown.
Finger tighten three Upright Bolts (47) with Upright
Washers (115) into the Upright (65). Note: It may be nec-
essary to move the Upright slightly to align the holes.
Attach the left Upright (not shown) in the same way.
(Note: There is no wire harness in the left Upright.) Do
not tighten the Upright Bolts (47) yet.
3
65
115
47
47
48