NorthStar Navigation GM1708 961XD - Manual (Page 76)

SECTION FOUR - Service/Maintenance
Page 66 961 INSTALLATION MANUAL Revision A
Figure 34: Select database to restore dialog box
> To restore only your setup and service options (user preferences),
press the USER PREFERENCE key.
> To restore only your waypoints and routes, press the WAYPOINTS
AND ROUTES
key (the 961 always restores waypoints and routes
together, since routes are comprised of waypoints).
> To restore all of the above, press the ALL key.
The RESTORE DATA dialog box appears, defined as either user preference
data, waypoint and route data, or all data, depending on which of the
above options you chose.
3. Insert the disk into the drive (either a floppy disk or a Zip disk), then
press the CONFIRM key. The RESTORING DATA dialog box appears
(defined as either user preference data, waypoint and route data, or
all data), asking you to wait while the 961 restores the data. This dia-
log box is followed by the SUMMARY OF DATA RESTORED dialog
box, showing the number of files restored.
4. Press the CONFIRM key to return to the DATABASE FUNCTION
screen. To use the restored database, you must restart the 961: Press
the PWR key to turn the 961 off, then press it again to restart. The
961 will now use the restored database.
Undoing a restore
After the 961 restores a database, you’ll have the option to undo the
restore operation. As long as the 961 power is on, you’ll always have this
option; however, if you restart the 961 by turning it off and then on, you’ll
lose the option to undo the restore.
1. At the DATABASE FUNCTION screen, press the UNDO RESTORE key.
This key only appears after you’ve restored a database to the 961 (a
database that hasn’t been restored can’t be undone). The SELECT A
RESTORED DATABASE TO UNDO dialog box appears. Depending on