Napco Security Technologies GEM-K2AS User Manual

Page 11

Advertising
background image

11

Disarming the System

1

Upon entry, the keypad sounder will turn on as a reminder to disarm the panel. The
red ARMED light will be on and the window will alternately display "DISARM" and
"XXXSEC", where "XXX" represents the entry time remaining in 10-second steps.
During the final 10 seconds, the sounder will pulse a warning signal.

2

Enter your User Code and press

U

. The sounder will silence and the red ARMED

light will go out, indicating that the system has been disarmed.

If you enter an invalid code, the keypad display "Wrong Code" Re-enter your code
immediately.


Alarm Indication / Silencing an Alarm

If the red ARMED light is flashing and “ALARM” is displayed, an alarm occurred while
you were out. Proceed with caution! If you suspect that an intruder may still be on the
premises, leave immediately and call authorities from a neighbor's phone.

To silence an audible alarm:

1

Enter your code and press

U

. After the system is disarmed, the window will continue

to display “ALARM” followed by the zone(s) violated.

2

To reset the display, note the zones violated, then press

C

.

T U R N I N G O F F T H E AL AR M ( D I S AR M I N G ) W H E N R E T U R N I N G


A C O N

DISARM/

XXXSEC


A C O N

Wrong/

Code


A C O N

ALARM/
ZONE02

Advertising