Napco Security Technologies GEM-K2AS - Manual (Page 13)

13
F I R E P R O T E C T I O N
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
Fire-Zone Alarm
If a fire is detected, “reset FIRE ALARM” will be displayed and the keypad sounder will
pulse.
1. If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire
Department from an outside phone.
2. Press the C button to silence the keypad sounder.
3. If there is no evidence of a fire, enter your User Code and press
U
to turn off the
alarm.
4. Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light
will be on.
After the alarm condition is corrected (thermostat cooled down; smoke cleared from
detector; etc.), pressing C again will reset the keypad within about 10 seconds.
Fire-Zone Trouble
1. If a problem in the fire-circuit is detected, “FIRE TB” (fire trouble) will display and the
sounder will pulse to signal a malfunction.
2. Press C to silence the sounder. Call for service immediately!
r e s e t F I R E A L A R M
A C O N
FIRE/
ZONEXX
T R O U B L E
A C O N
TRBL
41-XX