Network Technologies ST-C5KVM2ARS-1000S - Manual (Page 11)

NTI XTENDEX Extenders
8
Green Power LED
Yellow Traffic LED
CAT5 Cable to
Remote Unit
XTENDE X
NTI
R
Netw ork Te ch no lo gie s I nc
Rear View
ST-C5KVM2ARS-1000S Local Unit
d) If the Local Unit has RS232 support, connect the local user's RS232 cable from a touch screen
monitor to the RJ45 port on the Local Unit using the DB9M-to-RJ45 adapter and patch cable provided.
e) If the Local Unit has audio support, connect the cable from the local speakers to the 3.5mm
stereo audio jack with the speaker symbol on the Local Unit. (See Fig. 4) Connect a microphone to the
3.5mm stereo audio jack with the microphone symbol on the Local Unit.
Figure 4- Connect stereo speakers and microphone to XTENDEX Local Unit with audio support
Note: When two microphones are connected (one at local and one at remote), only one can be active at a time. See
mode charts on pages 12 and 13 for active microphone selection.
Connect The CAT5 Cable
Connect the CAT5 cable to the “Cat 5” port on the Local Unit. (See Fig. 5.) When properly inserted the cable end
should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other
end of the extension cable to the RJ45 wall outlet.
WARNING: Never connect the XTENDEX to an Ethernet
card, Ethernet router, hub or switch or other Ethernet RJ45 connector
of an Ethernet device. Damage to devices connected to the Ethernet
may result.
Figure 5- Connect CAT5 cable to Local Unit
!
Stereo
Speakers
XT ENDE X
NTI
R
Netw ork Te chn olo gie s I nc
Microphone
Rear View
ST-C5KVM2ARS-1000S Local Unit