Network Technologies ST-C5KVM2ARS-1000S - Manual (Page 13)

NTI XTENDEX Extenders
10
CAT5 Cable to
Local Unit
XTEN DEX
NTI
R
Netw ork Te chn olo gie s I nc
Rear View
ST-C5KVM2ARS-1000S Remote Unit
Figure 7- Connect speakers and microphone to the Remote Unit
Note: When two microphones are connected (one at local and one at remote), only one can be active at a time. See
mode charts on pages 12 and 13 for active microphone selection.
Connect the CAT5 cable
Make sure the CAT5 cable has been installed in accordance with
the “Preparation for Installation” instruction on page 3. Connect the
CAT5 cable to the “Cat 5” port on the Remote Unit. (See Fig. 8.)
When properly inserted the CAT5 cable end should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other end
of the extension cable to the RJ45 wall outlet.
WARNING: Never connect the XTENDEX to an
Ethernet card, Ethernet router, hub or switch or other Ethernet
RJ45 connector of an Ethernet device. Damage to devices
connected to the Ethernet may result.
Figure 8- Connect the CAT5 cable to the Remote Unit
!
Stereo
Speakers
XT ENDE X
NTI
R
Netw ork Te chn olo gie s I nc
Microphone
Rear View
ST-C5KVM2A-1000S Remote Unit