Connecting the scanner – Nikon AX-210 User Manual
Page 32
22
Nikon
ScanTouch 210 User's Manual
Remarks
•
The maximum number of SCSI devices that can be connected to one
computer is eight including the CPU. When using the scanner with
a host computer with a built-in SCSI hard disk or built-in CD-ROM,
note that SCSI ID numbers have been preassigned for the host CPU
and the SCSI devices.
•
The SCSI cable must not be extended beyond a total length of 19
feet (6 meters), or else failure may result.
•
Terminators must be attached to the devices located at both ends of
the SCSI chain.
If the host computer is a Macintosh, the Macintosh itself will
provide termination at one end of the chain.
If the host computer is an IBM PC/AT or compatible, equipped with
a SCSI board, the SCSI board itself will provide termination at one
end of the chain.
Note that when a SCSI chain connection is made inside a computer,
the end of the SCSI device inside the computer will become the end
terminal.
•
Before installing a SCSI board, be sure to read the user’s manual
provided with the board. The numbers for the I/O address, interrupt
level (INT) and DMA channel might conflict with other interface
boards and peripheral devices. If so, change them as explained in
the manual.
4. Connecting the Scanner