Nikon AX-210 - Manual (Page 33)

Nikon ScanTouch 210 User's Manual 23
4.4 Setting the SCSI ID
The SCSI ID for the ScanTouch 210 is set at “5” when the unit is
shipped. If other SCSI devices are connected to your computer, make
sure that the SCSI ID for the ScanTouch 210 is different from those
assigned to other SCSI devices.
Note that in the case of a host computer which has a built-in SCSI hard
disk or built-in CD-ROM, the ID numbers of the host CPU and each
SCSI device have already been assigned.
If the IDs are duplicated, you must change the ID number of the other
SCSI device or of the ScanTouch 210 to avoid any conflict.
Remarks
• To change the ID, confirm that the scanner power is off. The ID
cannot be changed when the power is on.
• Do not use SCSI ID 8 and 9 or A through F on your scanner. They
are for factory use only.
• As 7 has been assigned for the CPU and 0 has been assigned to the
built-in hard disk for a Macintosh, and 0 and 7 have also been
assigned to other personal computer systems, any number from 1 to
6 is recommended for the ID number.
• If conflicting ID numbers are assigned, your system might not
function, or important data on the hard disk might be destroyed. It
is therefore essential to check the ID numbers carefully before
connecting the scanner.
4. Connecting the Scanner