NETGEAR N300 ROUTER WNR2000 - Manual (Page 38)

NETGEAR Wireless-N 300 Router WNR2000 User Manual
2-8 Safeguarding Your Network
v1.3, July 2009
•
Channel. This field determines which operating frequency is used. It should not be necessary
to change the wireless channel unless you notice interference problems with another nearby
wireless network. The wireless router uses channel bonding technology to extend the
bandwidth for data transmission. For more information about the wireless channel
frequencies, see the online document that you can access from
“Wireless Networking Basics”
in Appendix B .
•
Mode. This field determines which data communications protocol is used. You can choose
from:
–
Up To 54 Mbps. Legacy mode, for compatibility with the slower 802.11b and 802.11g
wireless devices.
–
Up To 145 Mbps. Neighbor Friendly mode, for reduced interference with neighboring
wireless networks. Provides two transmission streams with different data on the same
channel at the same time, but also allows 802.11b and 802.11g wireless devices. This is
the default mode.
–
Up To 300 Mbps. Performance mode, using channel expansion to achieve the 300 Mbps
data rate. The WNR2000 router will use the channel you selected as the primary channel
and expand to the secondary channel (primary channel +4 or –4) to achieve a 40 MHz
frame-by-frame bandwidth. The WNR2000 router will detect channel usage and will
disable frame-by-frame expansion if the expansion would result in interference with the
data transmission of other access points or clients.
•
Security Options. The selection of wireless security options can significantly affect your
network performance. The time it takes to establish a wireless connection can vary depending
on both your security settings and router placement.
WEP connections can take slightly longer to establish. Also, WEP, WPA-PSK, and WPA2-
PSK encryption can consume more battery power on a notebook computer, and can cause
significant performance degradation with a slow computer. Instructions for configuring the
security options can be found in
“Choosing Appropriate Wireless Security” on page 2-1 . A
full explanation of wireless security standards is available in the online document that you can
access from
“Wireless Networking Basics” in Appendix B .
3. Click Apply to save your settings.
Note: The maximum wireless signal rate is derived from the IEEE Standard 802.11
specifications. Actual data throughput will vary. Network conditions and
environmental factors, including volume of network traffic, building materials
and construction, and network overhead, lower actual data throughput rate.