NetComm Wireless Network Adaptor NP545 - Manual (Page 6)

NP545 User Guide YML866Rev1
6 www.netcomm.com.au
2.2 hardware Installation
1. Connect one end of the USB cable to the Adapter.
2. Connect the other end of the USB cable to the USB port on your computer. Because the Adapter gets
its power from the host, there is no external power supply. The LED should light up when the Adapter is
plugged in and the PC is on.
2.3 Uninstall software
2.3.1 Uninstall the driver software from your Pc
1. On the Windows taskbar, click the start button, point to settings, and then click control Panel.
2. Double-click the system icon, click on the hardware tab in the system window.
3. Click on the device Manager button, double-click Network adapters, and then right-click NP545
Wireless adapter.
4. Click Uninstall..., the system will uninstall the driver software of the adapter from your PC.
2.3.2 Uninstall the utility software from your Pc
1. On the Windows taskbar, click the start button, point to settings, and then click control Panel
2. Double-click the add/remove Programs icon, find the NP545 program from the installed program list,
highlight it and click the remove button.
3. Following the Install Shield Wizard will uninstall the utility software from your PC.