NETGEAR XM128 ISDN - Manual (Page 106)

Reference Guide for the Model XM128 ISDN Digital Modem
C-4 AT Command Set Reference
CPn Loopback 4 control
CP0 Disable Loopback 4
CP1 Enable Loopback 4
CRn n=0-3
0 * Resumes a previously suspended call; n is the call identifier (Europe).
CSn n=0-3
0 * Suspends a call; n is the call identifier (Europe).
Ds Dial s numbers and options that follow. See also S-register 38.0 and 35.4. For
a description of Extended S-registers, refer to Table D-4 on page D-5 in
Appendix D, “Status Registers and Result Codes."
The s options are listed as follows:
, Pause for a time specified in S6. Remaining digits are dialed as in-band
DTMF.
+ Prefix for the second number string, to be used in making bundling or MPPP
calls.
W Wait for second dial tone. Remaining digits are dialed as in-band DTMF (ISDN
numbering options).
Y0 Unknown type of number
Y1 International number
Y2 National number
Y3 Network-specific number
Y4 Subscriber number
Y6 Abbreviated number
Z0 Type of subaddress, NSAP with AFI=$50, IA5 characters
Z2 Type of subaddress, user specified, IA5 characters
N0 Unknown numbering plan
N1 ISDN/Telephony numbering plan (CCITT E.164/E.163)
N3 Data numbering plan (CCITT X.121)
N8 National standard numbering plan
N9 Private numbering plan
/ Called party subaddress delimiters
Format of “s” [[Yn][Nn]called_party_number][[W][,]]inband_dtmf_number
or
[[Yn][Nn]called_party_Number][/[Zn]called_party_subaddress/]
Table C-1. Basic AT command set (continued)
Command Options Function and description