NETGEAR XM128 ISDN - Manual (Page 132)

Reference Guide for the Model XM128 ISDN Digital Modem
D-18 Status Registers and Result Codes
S119=
(continued) 2 0 * 0 Disables point-to-multipoint
signaling DDI function.
4 4 Enables point-to-multipoint
signaling DDI function.
3 0 * 0 Inbound call ignored when no
MSN (EAZ) is matched.
8 8 Inbound call accepted using
default protocol when no MSN
(EAZ) is matched.
4 0 * 0 V.110 user rate = 19200 bps if DTE
speed is greater than 19200 bps.
16 10 V.110 user rate = 38400 bps if DTE
speed is greater than 38400 bps.
5 0 * 0 Enables normal MSN function. &ZIn
32 20 Treats the number assigned by
&ZI=n... as subaddress, and
matches with the called party
subaddress for inbound call
routing.
S120= Accumulated charging unit (MSB
byte) for B1 channel.
S121= Accumulated charging unit (LSB
byte) for B1 channel.
S122= Accumulated charging unit (MSB
byte) for B2 channel.
S123= Accumulated charging unit (LSB
byte) for B2 channel.
S124= Empties IP packet interval for PPP. +000
0-255 0-FF Units of 1 sec.
S125= 1-6 *0 Sub-persist time interval. KSxn
7 0 *0 S125b1-6 is in second unit. KSSn
128 80 S125b1-6 is in minute unit. KSMn
Table D-4. Extended S-registers ATSn=x (continued)
Command Bit Decimal Hexadecimal
Function and
description Default or
reference