NorthStar Navigation Northstar 2 kW User Manual
Page 33
Northstar 2 kW Radar Installation Manual
33
4.6
Connect the 2 kW radar processor to an 8000i display
You are recommended to use the following configuration when connecting the radar processor to an
8000i display, where:
A is the (optional) NMEA Compass
B is the Circuit breaker/Fuse box
C is the vessel's Ground
Alternative 8000i system configurations are possible. For further information please refer to the
Northstar 8000i System installation documentation.
4.6.1
Configure the remote power control for an 8000i
NOTE: At the time of printing this manual, the 8000i does not support remote power control of
network modules. This feature will be added in future release.
The radar processor supports this feature through Pin 12 on the NMEA/Comms port.
If you want the radar processor to power ON automatically whenever power is applied, leave Pin 10
and Pin 12 of the NMEA/Comms connector as No Connect.