NetComm NP730 - Manual (Page 2)

NETCOMM LIMITED ABN 85 002 490 486 PO Box 1200, Lane Cove NSW 2066 Australia
P: 02 9424 2070 F: 02 9424 2010 E: [email protected] W: www.netcomm.com.au
Trademarks and registered trademarks are the property of NetComm Limited or their respective owners. Specifications are
subject to change without notice. Images shown may vary slightly from the actual product.
NetComm NP730
802.11b/g Wireless Outdoor Access Point
TECHNICAL SPECIFICATIONS
Your NetComm dealer:
Included accessories:
25M RJ45 CAbLE 2M RJ45 CAbLE bRACKET DC INJECTOR
NP730 Wireless Outdoor Access Point
The NetComm NP730 is an outdoor device that will operate in access point, repeater and bridge mode.
Designed to meet the needs of today’s most demanding wireless LAN deployments, the NetComm
NP730 offers a 5DBI antenna with a 200mw inbuilt booster to enhance wireless network coverage. The
NP730 offers a solution to create a reliable and scalable wireless network through its multi mode set
up the device can be used in many instances to increase and enhance wireless coverage.
Operating in the 802.11g wireless spectrum the device provides 54mpbs wireless coverage and is
backwards compatible to 802.11b. Whether you are needing to increase wireless connectivity within
an office, warehouse, shop or to extend the range on the NetComm HS960 wireless hotspot or if
you are looking to increase outdoor coverage, each external access point offers simple installation
and a simple way to increase your coverage.
STANDARDS COMPLIANCE
• IEEE 802.11b/g
• IEEE 802.3
• IEEE 802.3u
SDRAM
• 8 M Byte
FLASH
• 2 M Byte
RADIO FREqUENCY TYPE
• DSSS / OFDM
MODULATION
• IEEE 802.11b: CCK,DQPSK,DBPSK
• IEEE 802.11g: OFDM with BPSK, QPSK, 16QAM, 64QAM
FREqUENCY bAND
• America/FCC: 2.412~2.462 GHz (11 channels)
• Europe CE/ETSI: 2.412~2.472 GHz (13 channels)
TRANSMISSION POWER
• IEEE 802.11b: 20dBm
• IEEE 802.11g: 20dBm
TRANSMISSION RATE
• IEEE802.11b: 1/ 2/ 5.5/ 11 Mbps
• IEEE802.11g: 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
• Super G: up to 108Mbps
ACCESS POINT INTERFACES
• Auto MDI/MMDI-X Ethernet 10/100Base-TX: RJ-45
SENSITIvITY
• -86dBm @ 11Mbps,PER< 8%
• -64dBm @ 54Mbps,PER< 10%
ANTENNA TYPE
• 5dBi detachable antenna with N type connection
SECURITY SYSTEMS
• 64-bit/128-bit/152-bit/ WEP encryption
• Wi-Fi Protected Access(WPA)
WIRELESS SETTINg
• Operation Mode-AP/Wireless Client/Repeater/
Bridge(WDS)PtP and PtMP Mode
SOFTWARE/FIRMWARE
• Site Survey
• DHCP Client
• Suppressed SSID
• Wireless access control by MAC address
(deny or accept)
• WPA Support (WPA personal and enterprise)
• Web-based configuration
• Windows ”Locator” program to help find IP in DHCP
client mode
• Firmware upgrade and configuration backup via Web
• Reset to default by WebUI
OPERATINg ENvIRONMENT
• Operating Temperature: -10 ~ +70°C
POWER
• DC 12 Volt + 5%; 1.5A (Max.)
• AC adapter AC 100V ~ 240V
REgULATORY APPROvAL
• FCC Part 15 B (US)
• CE
• C-Tick
NETWORK MANAgEMENT
• System OS Support
• Windows 2000/XP
STANDARD ACCESSORIES
• 25M RJ45 Cable
• 2M RJ45 Cable
• Bracket
• DC Injector
POE Injector
Power Point
NP730
Access Point
Please note: This cable is part of the NP730 unit
Wireless Device
(Router/Modem
Router/Hotspot)