Network Technologies SM-nXm-AV-LCD - Manual (Page 10)

7
• Connecting video only
To make a video connection without changing the current audio connection, use any of the following commands:
1. <OUT>, <▲>, Single digit output port number, <IN> or <ENTER>, Single digit input port number, <ENTER>.
Ex: <OUT> <▲> 3 <IN> 5 <ENTER>
2. <OUT>, <▲>, Double digit output port number, Double digit input port number.
Ex: <OUT> <▲> 03 05
All video outputs can be connected to one video input by using <*>:
1. <*>, <▲>, Single digit input port number, <ENTER>
Ex: <*> <▲> 5 <ENTER>
2. <*>, <▲>, Double digit input port number
Ex: <*> <▲> 05
Volume Control
The volume level can be adjusted on each output port.
• To increment <▲> or decrement <▼> the volume, use the following command:
<OUT>, <▼>, Double digit output port number, <▲> increment or <▼> decrement, <ENTER>
Ex 1: <OUT> <▼> 03 <▲> <▲> <▲> <ENTER>
This will increment the volume by +6dB (2dB/ press).
Ex 2: <OUT> <▼> 14 <▼> <▼> <ENTER>
This will decrement the volume by -4dB.
• To Mute, use the command:
<OUT>, <▼>, Double digit output port number, the <0> key, <ENTER>
Ex: <OUT> <▼> 03 0 <ENTER>
This will mute output 3
• To Un-mute, use the instruction:
<OUT>, <▼>, Double digit output port number, the <1> key, <ENTER>
Ex: <OUT> <▼> 03 1 <ENTER>
This will un-mute output 3
Memory Functions
There are 10 memory locations available to save connection configurations.
• Saving Connections
To save all current connections, use the following command:
<*>, <OUT>, Memory location, <ENTER>
Ex: <*> <OUT> 5 <ENTER>
• Restoring Connections
To restore connections from memory, use the following command:
<*>, <IN>, Memory location, <ENTER>
Ex: <*> <IN> 5 <ENTER>
Serial Menu
The serial menu is used to configure the RS-232 port.
• The baud rate is selected from the “Baud Rate Menu.” To access this menu, use the command:
<MENU>, the <1> key
Next, press the keypad number corresponding with the desired baud rate:
<1> – 1200
<2> – 2400
<3> – 4800
<4> – 9600
Ex: <MENU> 1 4
This will select 9600 baud
• To set the switch address, use the following instruction:
<MENU>, the <2> key, Double digit address (from 01 to 15)
Ex: <MENU> 2 03
This will set the address at 03