Netopia 3347W - Manual (Page 43)

Technical Specifications and Safety Information A-5
• Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
the network inter face.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk
of electric shock from lightning.
• Do not use the telephone to repor t a gas leak in the vicinity of the leak.
FCC Part 68 Information
FCC Requirements
1. The Federal Communications Commission (FCC) has established Rules which permit this device to be
directly connected to the telephone network. Standardized jacks are used for these connections. This
equipment should not be used on par ty lines or coin phones.
2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should
be disconnected until the source of the problem can be determined and until repair has been made. If this
is not done, the telephone company may temporarily disconnect ser vice.
3. The telephone company may make changes in its technical operations and procedures; if such changes
affect the compatibility or use of this device, the telephone company is required to give adequate notice of
the changes. You will be advised of your right to file a complaint with the FCC.
4. If the telephone company requests information on what equipment is connected to their lines, inform them
of:
a. The telephone number to which this unit is connected.
b. The ringer equivalence number. [0.XB]
c. The USOC jack required. [RJ11C]
d. The FCC Registration Number. [XXXUSA-XXXXX-XX-E]
Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN) is used to determine
how many devices can be connected to your telephone line. In most areas, the sum of the REN's of all
devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring
properly.
FCC Statements
a) This equipment complies with Par t 68 of the FCC rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
b) List all applicable cer tification jack Universal Ser vice Order Codes (“USOC”) for the equipment: RJ11.
c) A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Par t 68 rules and requirements adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is
also compliant. See installation instructions for details.