NISSAN 2010 Altima Coupe User Manual
Page 93
3. Select “Stored Routes”. A list screen is
displayed.
4. Select the preferred route from the list. The
route to the destination is set.
5. The entire route is shown on the map. Se-
lect “Start” after confirming the location of
the displayed destination. The system sets
the destination to the selected location and
starts calculating a route.
INFO:
● Even after setting a destination, the location of
the destination can be adjusted, the route can
be stored, etc.
“PROCEDURES AFTER SETTING
A DESTINATION” (page 5-2)
● The stored route includes only locations (des-
tination and waypoints) and route calculation
conditions, not the route itself. Therefore,
when the destination is set using a stored
route, a different route may be suggested if
the current vehicle location is different from
the one when the route was stored.
NDE0048
NDE0049
NDE0050
4-22
Setting a destination