NetComm 4-port and 8-port Gateways Gateway Series - Manual (Page 79)

SmartVoice Gateway(s) User Guide 79
YML83 Rev
IP Configuration Settings (WAN port)
Static IP Settings
NOTE: Complete static public/private IP settings should include a static IP (Option
1 under 114), IP address (111), Subnet Mask (11), and Default Gateway (113).
Please contact your local Internet Service Provider (ISP) if you have any questions.
Function Command
Select a Static IP • After entering IVR mode, dial 114.
• After hearing “Enter value”, dial 1 (to select static IP)
IP address Settings • After entering IVR mode, dial 111. After hearing “Enter value”, enter
your IP address, followed by “#”.
Example: If the IP address is 19.168.1.00, dial 19*168*1*00#.
Subnet Mask Settings • After entering IVR mode, dial 11. After hearing “Enter value”, enter
your subnet mask, followed by “#”.
Example: If the mask value is 55.55.55.0, dial 55*55*55*0#.
Default Gateway Settings • After entering IVR mode, dial 113. After hearing “Enter value”, enter
your default gateway’s IP address, followed by “#”.
Example: If the Default Gateway is 19.168.1.54, dial 19*168*1*54#.
Save Settings and Restart • To save settings, dial 509 (Save Settings). The system will save the
settings. Please restart the system. Wait for about 40 seconds for the
system to restart, and then enter 101 to check if the IP address is
retained. If the IP address is not repeated, it indicates that Gateway has
not been properly connected; please check if the cable connection is
correct.
Dynamic IP (DHCP) Settings
After entering IVR mode, dial 114.
After hearing “Enter value”, dial  (to select DHCP).
Saving settings –press 509 (Save Settings). Please restart the system. After the system is restarted,
press 101 to check if the IP address is retained.
NOTE: If the system does not repeat the IP address, it indicates that the Gateway
failed to communicate with a DHCP server. Please check your DHCP server or
consult your ISP if they issue an IP address to you via DHCP protocol.
ADSL PPPoE Settings
NOTE: Complete PPPoE settings should include: Select PPPoE (Option 3 of 114),
PPPoE account (11) and PPPoE password (1).
Please contact your local Internet Service Provider (ISP) if you have any questions.