Numark Industries TT-100 - Manual (Page 10)

PRO TT-2 Turntable
- The Leader in DJ Technology
©2000 Industries - 10 - http://www.numark.com
GENERAL OPERATING INSTRUCTIONS
1. Turn the power dial to turn on and the speed indicator and the strobe-illuminator will light up.
2. Turn on and raise the target light for illuminating the stylus tip by pushing the target light button.
3. Place a record on the turntable mat. When playing a 45rpm record with a large center hole; place the 45-
rpm adapter on the center spindle.
4. Set the rotation speed (33/45/78) to match the record.
5. Release the arm clamp.
6. Set the cueing lever to the up position.
7. Press the Start/Stop button and the turntable platter will start to rotate.
8. Move the tonearm over the desired groove.
9. Set the cueing lever to the down position, the tonearm will descend slowly onto the record and play begins.
10. Set the desired pitch adjust range by depressing the QUARTZ button until the desired pitch is reached.
Options are +/-10% or +/-20%.
11. Adjust the pitch to a desirable speed. During play, observe the strobe dots. If the strobe dots appear to the
right, the pitch is slower than the rated speed. If they flow to the left, the pitch is faster than the rated speed.
If the strobe dots appear stationary, which means the platter is in normal turntable speed, move the pitch
control slider up or down to adjust the speed.
12. To suspend play, lift tone arm with cueing lever.
13. When play is finished, raise the cueing lever, move the tonearm to the armrest and secure the tonearm with
the arm clamp.
14. Turn off the target light off by pushing the light back down.
15. Press the Start/Stop button to stop the platter rotating.
16. Turn the power dial to turn off the power.
MAINTENANCE
Routine maintenance should be performed by cleaning the stylus periodically with a soft brush to
prevent the accumulation of dust. When the sound becomes distorted or noisy, check the stylus. If it is worn
out, replace with a new one. From time to time, the dust cover and turntable cabinet should be wiped with a
soft, dry cloth. Use of any volatile materials as alcohol, thinner, benzene, etc., may remove the paint or damage
the luster and should not be used.