Numark Industries TT-100 User Manual
Page 9
PRO TT-2 Turntable
- The Leader in DJ Technology
©2000
Industries
- 9 -
http://www.numark.com
REAR PANEL DIAGRAM
27
28
29
30
31
32
33
34
27. Removable Lid - Protects the turntable from dirt and dust.
28. Hinge Assembly - Holds the lid and turntable together. Attach now by sliding the bottom tabs of the Hinge
Assembly into the Hinge Holders.
29. Platter Speed Output - This output is to be used with external devices that require platter speed information.
30. Remote Start/Stop - This is used with external control devices.
Tech note: This circuit is normally open. Use a momentary switch and a 1/4” mono plug, to change play
states of the unit.
31. Adjustable Feet - Turn feet to level the platter surface.
32. Phono Output - Plug these into your mixer or preamplifiers’ turntable input.
33. Ground Cable - Attach to the ground screw on your mixer or preamplifier to prevent turntable hum.
34.
Power Cord - Plug this into an appropriate power outlet after checking your power setting switch (18) under
the platter. Note: Please refer to CAUTION on page 2 concerning proper use of power.
Your assembly should now be complete. Place your turntable on a vibration free level
surface and attach to your mixer or preamplifier. If you are using the turntable for slip
cueing, scratching, or beat mixing music you will want to use a slipmat and not a rubber
mat. Do not force the platter to stop moving while the motor is engaged. Quality slipmats
should be used to hold records in position. Forcing the motor to stop can damage the
motor assembly.