NAD T 571 - Manual (Page 15)

CONNECTIONS PAGE 15
Connecting to an Stereo System
You can listen to the sound of audio CDs and DVD video discs in stereo.
12V
TRIGGER
IN
To audio inputs
Stereo system
To VIDEO OUT To AUDIO OUT (L/R)
S-video cable (Not supplied)
To S-VIDEO OUT
To video input
To S-video input
TV or monitor with
audio/video inputs
Audio cable
(supplied)
Video cable
(supplied)
❍ Refer to the owner’s manual of your stereo system for operating instructions.
❍ Before you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
❍ If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case, move the DVD
player away from the tuner and radio.
❍ The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
❍ Turn off the receiver before you connect or disconnect the DVD player’s power cord. If you leave the receiver power on, the
speakers may be damaged.
Warning
Do not set the Digital Audio Output of this DVD player to “Dolby Digital” unless you are connecting the DIGITAL OUT jack of this DVD
player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the
speakers (Refer to “Selecting Digital Audio Output” on page 25).
Notes
If the TV has an S-video input, connect
the DVD player with the S-video cable.