NAD L 76 - Manual (Page 12)

ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
12
RADIO RECEPTION
AUTO TUNING
1 Select the Tuner by turning the Source selector.
2 Select the AM or FM by pressing the AM/FM selector button.
3 Press the Tune/Preset MODE button to change to TUNING mode. (The PRESET CH. indicator disappears
from the display.) This button is used to select Tuning or Preset scan mode.
4 Press the UP or DOWN TUNING button (within 0.5 to 2 seconds). The next station broadcasting at a
frequency higher or lower than that of the current station is automatically detected and tuned in. By
pressing and holding the TUNING button for longer than 2 seconds, it will continue to scan (three
times faster than normal speed).
MANUAL TUNING
Manual Tuning is generally used to tune to stations broadcasting a signal that is too weak to be received
by Auto Tuning.
1 Select the Tuner by turning the Source selector.
2 Select the AM or FM by pressing the AM/FM selector button.
3 Press the Tune/Preset MODE button to change to TUNING mode. (The PRESET CH. indicator disappears
from the display.)
4 When the Tune/Preset Mode button is pressed momentarily (0.5 second or less), the frequency
changes by a fixed step.
FM : 50 kHz steps, AM : 9 kHz steps
• Press the AM/FM button for more than 4 seconds then steps changes.
PRESET TUNING
This facility is used to store AM and FM stations in presets from 1 to 30.
AUTOMATIC MEMORY PRESETTING
1 Select the Tuner by turning the Source selector.
2 Select the AM or FM by pressing the AM/FM selector button.
3 Press the MEMORY button for a while (for more than 1.5 seconds).
a) The start frequency will show in the display:
87.5 MHz in FM, 522 kHz in AM.
b) The frequency and display will automatically scan.
c) The frequency shown in the display will rapidly change. As each station is located a preset number
will appear in the display indicating which preset MEMORY button has been assigned to the station
located. The scanning process will continue to operate in this fashion until 30 stations have been
found and entered into the preset memory or when there are no more stations to be found on the
waveband chosen. The memory indicator will extinguish and let you hear the last station to be
memorized. To listen to the memorized station select the band required and press the numeric keys
1, 2, 3 etc.
4 The last memorized preset of each band will be displayed when Auto Memory is completed. Check
the programmed frequencies with TUNING/PRESET UP, DOWN button.
1
4 3 2
1
4 3 2