NordicTrack NTB12920 - Manual (Page 6)

6
1.
Attach a Wheel (11) to the Stabilizer (2) with an
M10 x 63mm
Button Head Bolt (21), an Axle (12),
an M10 Washer (22), and an M10 Nylon Locknut
(23). Repeat this step with the other Wheel.
2. Press a 50mm x 75mm Inner Cap (10) into the
Frame (1). Press two 38mm x 100mm Inner Caps
(9) into the arms on the Frame.
Attach the Frame (1) to the Stabilizer (2) with four
M10 x 115mm Carriage Bolts (20), four M10
Washers (22), and four M10 Nylon Locknuts (23).
1
2
Before beginning assembly, make sure you
understand the information in the box
above.
1
10
9
2
23
23
22
22
11
11
12
22
23
21
2
20
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The included Allen wrenches and the following
tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
ASSEMBLY