Assembly, Operation – Ryobi RY08576 User Manual

Page 10

Advertising
background image

10

ASSEMBLY

CAUTION:

Make all adjustments to the harness straps before start-
ing the blower to avoid the possibility of injury.

ADjUSTING HARNESS AND WAIST STRAPS

Straps should be adjusted to a comfortable position before
starting the blower.
To adjust harness strap assembly:

Blower should be in operating position before adjusting

the harness straps. Slip arm through harness strap and
onto shoulder, then repeat for the other shoulder.

There are three possible height adjustment positions that

can be used to easily adjust harness.

Slip top buckle of harness from adjustment slot and

position to desired height location.

Tighten (pull down on strap) or loosen (lift up on tab of

strap buckle) each harness strap as needed, until each
is adjusted to a comfortable operating position.

Chest strap should be tightened or loosened until adjusted

to a comfortable operating position.

Fig. 5

OPERATION

WARNING:

Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.

WARNING:

Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.

APPLICATIONS

You may use this product for the purposes listed below:

Clear leaves and other debris from your lawn

Keep decks and driveways free from leaves and pine
needles

WARNING:

Gasoline is extremely flammable and explosive. A fire or
explosion from gasoline will burn you and others.

MIXING THE FUEL

This product is powered by a -cycle engine and requires
pre-mixing gasoline and -cycle oil. The mixture should be
at a 50:1 ratio, using Premium Exact Mix™ -cycle engine
oil. If Premium Exact Mix™ -cycle engine oil is not avail-
able, use a high quality synthetic -cycle engine oil, mixed
at a 50:1 ratio. See chart later in this section.
To mix the fuel:

Use a clean container that is approved for use with gaso-

line.

Mix the Premium Exact Mix™ -cycle engine oil with

unleaded gasoline in the container, according to the
instructions on the oil package.

NOTE: This engine is certified to operate on unleaded gaso-
line intended for automotive use with an octane rating of 87
[(R + M) / ] or higher. Do not use automotive oil or -cycle
outboard oil.
NOTE: Premium Exact Mix™ fuel mixture will stay fresh up
to 30 days. DO NOT mix quantities larger than usable in a
30 day period.

To adjust waist strap assembly:

Waist strap should be tightened or loosened until adjusted

to a comfortable operating position.

ADjUSTING THROTTLE CONTROL HANDLE

See Figure 5.

Loosen throttle control handle locking screw by twisting

counterclockwise.

Move throttle control handle to desired position and

secure locking screw by twisting clockwise.

PREMIUM EXACT MIX™ (50:1)

GASOLINE

OIL

1 gallon (US)

.6 oz.

1 liter

0 cc (0 ml)

locking

screw

throttle

control hAnDle

Advertising
This manual is related to the following products: