Ryobi RY08576 - Manual (Page 9)


nozzle
throttle
cAble
WARNING:
Disconnect the spark plug wire before assembling parts.
Failure to do so could result in possible serious personal
injury.
ASSEMBLING THE BLOWER TUBES
See Figures 2 - 4.
 Place a tube clamp on blower past the raised tabs.
Assemble the elbow tube onto blower by aligning raised
tabs on blower with slots on elbow. Tighten tube clamp
onto elbow.
 Attach bellows onto elbow tube by placing a tube clamp
on one end of the bellows then press bellows onto elbow
tube. Tighten tube clamp.
 Place a tube clamp on other end of bellows. Press bellows
onto throttle control handle tube. Tighten tube clamp.
NOTE: The position of the throttle control handle may be
adjusted for comfort after the blower is strapped onto the
operator’s back.
 Join the straight tube and nozzle together by aligning
raised locking tabs on straight tube with the raised locking
slots on nozzle and twist to secure.
 Assemble the connected lower tubes to the throttle
control handle tube by aligning raised locking tabs on
the throttle control handle tube with the raised locking
slots on connected lower tubes by twisting to secure.
NOTE: Check all locking connections after initial run to
ensure they are tightly secured.
 Hold the throttle cable against the bellows and install the
cable ties. Cable ties should be tight enough to retain
the throttle cable to the bellows but still allow for move-
ment.
ASSEMBLY
bellows
elbow
tUbe
Fig. 
Fig. 3
Fig. 4
throttle control
hAnDle tUbe
cAble tie
throttle control
hAnDle tUbe
strAight tUbe
throttle
control
hAnDle tUbe
tUbe clAmP