Ryobi MS181 - Manual (Page 20)

Page 20
45
30 1 5
0
1 5
22 .5
30
45
4
5
31 .6 2
22.5 31.62
4 5
3 0 3 0
15 15
5
22.5 22.5
31.62 31.62
R O T A T I O N
4 5
3 0 3 0
15 15
5
22.5 22.5
31.62 31.62
R O T A T I O N
45
30 1 5
0
1 5
22 .5
30
45
4
5
31.62
22.5 31.62
ADJUSTMENTS
■ Using the 6 mm hex key provided, loosen the
socket head screws that secure the mounting
bracket to the miter table.
See Figure 26.
SQUARING THE BLADE TO THE
MITER TABLE
See Figures 27 – 31.
■ Remove battery pack from saw.
WARNING:
Failure to remove battery pack from your saw
could result in accidental starting causing possible
serious personal injury.
■ Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
■ Lift up the miter table clamp.
■ Rotate the miter table until the pointer is posi-
tioned at 0°.
■ Push the miter table clamp back down.
■ Loosen bevel lock knob and set saw arm at 0°
bevel (blade set 90° to miter table). Tighten bevel
lock knob.
■ Place a combination square against the miter
table and the flat part of saw blade.
Note: Make sure that the square contacts the flat
part of the saw blade, not the blade teeth.
■ Rotate the blade by hand and check the blade-to-
table alignment at several points.
■ The edge of the square and the saw blade should
be parallel as shown in figure 27.
Fig. 27
VIEW OF BLADE SQUARE
WITH MITER TABLE
COMBINATION
SQUARE
FENCE
Fig. 25
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER TABLE
BLADE
FENCE
FRAMING SQUARE
Fig. 26
6 mm
HEX KEY
MITER TABLE
■ Rotate the mounting bracket left or right until the
saw blade is parallel with the square.
■ Retighten the screws securely and recheck the
blade-to-fence alignment.
MOUNTING
BRACKET
6 mm SOCKET
HEAD SCREW(S)
MITER TABLE
BLADE