Ratoc Systems CB31U - Manual (Page 50)

48
3. Using SCSI devices
3. Using SCSI devices
3-1. Connecting the SCSI device
1. Attach an external active terminator to the SCSI device, as shown below. If the SCSI device has an
internal terminator and the switch, set it on state. Refer to the SCSI device manual if you are not sure how
to activate termination.
2. Be sure that at least one SCSI device connected to the CB31U supplies termination power to the SCSI
bus. Refer to the SCSI device manual if you are not sure whether the SCSI device provides termination
power.
3. Be sure that each SCSI device has a unique SCSI ID, ranging from 0 to 6. The CB31U uses SCSI ID 7.
You can usually change a SCSI ID with a switch on the back of the SCSI device. For more information,
refer to the SCSI device’s manual.
4. Connect the PCMCIA connector at the end of the SCSI cable to the CB31U, as shown below.