Roland SP-404SX - Manual (Page 39)

39
D
eu
tsc
h
Fra
nç
ais
Italiano
Español
Por
tug
uês
N
eder
lands
English
List of Functions
You can access the following functions by holding down the [ FUNC] button and pressing the corresponding pad .
For details on each function, refer to the page listed in the table below .
Pad Function Description Page
TAP.TEMPO PAUSE Stops all sound p ..12
1 COPY Copies a sample or pattern p ..31,.p ..34
2 EXCHANGE Exchanges the patterns or samples of pads p ..31,.p ..34
3 IMPORT Imports WAV/AIFF fi les from the SD card p ..36
4 AUTO.TRIG.LEVEL Adjusts the trigger level for auto sampling p ..25
5 BACKUP.LOAD Loads backup data p ..37
6 BACKUP.SAVE Saves backup data p ..37
7 ILLUMINATION Display illumination and sleep settings p ..40
8 EFFECT.LIMIT Used to make settings for Eff ect Limit mode p ..42
9 MIDI.CH Changes the MIDI channel p ..47
10 MIDI.SYNC Synchronization with an external MIDI device p ..47
11 INPUT.GAIN Adjusts the input gain p ..39
12 OUTPUT.GAIN Adjusts the output gain p ..39
Other Functions
Adjusting the Input Gain
Here’s how to adjust the SP-404SX’s input gain .
MEMO
If the PEAK indicator stays lit and it’s not possible to
adjust the volume of your audio source device, set the
SP-404SX’s input gain to “-10 dB .”
1. Hold.down.the.[FUNC].button.and.press.the.pad.
[11].(.INPUT.GAIN) .
2. Turn.the.[CTRL.3].(LEVEL).knob.to.make.the.
setting .
The [REC] button will blink when you turn the knob .
Range: -10 dB, 0 dB
3. Press.the.[REC].button.to.confi.rm.the.setting .
MEMO
• If you decide to cancel, press the [CANCEL] button .
• This setting is retained even while the power is turned
off .
LINE IN jacks
MIC IN jack
PEAK
indicator
Input Gain
[MIC IN]
knob
Adjusting the Output Gain
Here’s how to adjust the overall volume of the SP-404SX .
MEMO
The SP-404SX has a maximum polyphony of twelve
notes . There will be a major diff erence in the volume
depending on whether one note or twelve notes are
being produced . If you are playing only a few pads at
a time, or if you have connected the SP-404SX to a DJ
mixer or other device, and are using it as an eff ects
processor, raising this internal processing level will
allow you to output a higher level . If you are playing a
larger number of pads simultaneously and the sound
is distorting, you should lower this internal processing
level .
1. Hold.down.the.[FUNC].button.and.press.the.pad.
[12].(.OUTPUT.GAIN) .
2. Turn.the.[CTRL.3].(LEVEL).knob.to.adjust.the.
setting .
The [REC] button will blink when you turn the knob .
Range: -3 dB, 0 dB, 3 dB, 6 dB, 9 dB, 12 dB
3. Press.the.[REC].button.to.confi.rm.the.setting .
MEMO
• If you decide to cancel, press the [CANCEL] button .
• This setting is retained even while the power is turned
off .