Rosewill RC403 - Manual (Page 5)

4
User Manual PCI 56Kbps V.92 Data/fax Voice Modem Card RC403
Result Codes
OK <value> = 0 or .
ERROR Otherwise.
O - Return to On-Line Data Mode
This command specifies that the modem will enter the on-line data mode from the on-line
command mode with or without a retrain. If in the off-line command mode when this command
is entered, the modem reports ERROR.
Syntax
O[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enters on-line data mode from the on-line command mode without a retrain. Handling is
determined by the Call Establishment task. Generally, if a connection exists, this command
connects the DTE back to the remote modem after an escape (+++).
 Performs a retrain then enters on-line data mode from the on-line command mode.
Result Codes
OK <value> = 0 or  and a connection exists.
ERROR Otherwise or no connection exists
L - Speaker Volume
This command sets the speaker volume control according to the parameter supplied.
Syntax
L[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Low speaker volume.
 Low speaker volume. (Default.)
2 Medium speaker volume.
3 High speaker volume.
Result Codes
OK <value> = 0 to 3.
ERROR Otherwise.
M - Speaker Control
This command controls speaker on or off according to the supplied parameter.
Syntax
M[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Speaker off.
 Speaker on during call establishment, but off when receiving carrier. (Default.)
2 Speaker on.
3 Speaker is off when receiving carrier and during dialing, but on during answering.
Result Codes
OK <value> = 0 to 3.
ERROR Otherwise.