Maintenance and repair instructions – Ryobi 770rEB User Manual

Page 17

Advertising
background image

MAINTENANCE AND REPAIR INSTRUCTIONS

17

FREQUENCY

MAINTENANCE REQUIRED

REFER TO:

Before Starting Engine

Fill fuel tank with correct oil and fuel mixture.

Page 11

Every 10 Hours

Clean and re-oil air filter.

Page 20

Every 50 Hours

Check spark plug condition and gap.

Page 22

NOTE: Some maintenance procedures may require

special tools or skills. If you are unsure about
these procedures take your unit to an authorized
service dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.

WARNING:

To prevent serious personal

injury, never do maintenance or repairs with
unit running. Always do maintenance and
repairs on a cool unit. Disconnect spark plug
wire to ensure the unit will not start.

Fig. 21

Fig. 23

Fig. 22

LINE INSTALLATION

Always use genuine Ryobi 0.080 inch (2.03 mm.)
replacement line. Line other than specified may make
the engine overheat or fail.

WARNING:

To prevent serious personal

injury, never use metal-reinforced line, wire,
or rope, etc.. These can break off and
become a dangerous projectile.

There are two methods to replace the trimming line.
• Wind the inner reel with new line

• Install a prewound inner reel

NOTE: Replacement line Part # 610375, or a prewound

reel, Part # 153577 can be purchased from your
local authorized dealer.

Winding the Existing Inner Reel
1. Hold the outer spool with one hand and unscrew the

Bump Knob™ counterclockwise (Fig. 21). Inspect
the bolt inside the Bump Knob™ to make sure it
moves freely. Replace the Bump Knob™ if damaged.

NOTE: A Bump Knob™, Part # 153066 can be

purchased from your local authorized dealer.

4. Use a clean cloth to clean the inner reel, spring,

shaft, and inner surface of the outer spool (Fig. 23).

2. Remove the inner reel from the outer spool (Fig. 22).

3. Remove spring from the inner reel (Fig. 22).

NOTE: An inner reel spring, Part # 610317 can be

purchased from your local authorized dealer.

Inner Reel

Outer Spool

Spring

Bump Knob™

Shaft

Advertising