Runco CX-40HD - Manual (Page 46)

Operation
36 Runco CX-40HD/CX-46HD Owner’s Operating Manual
PRE
L
IMINAR
Y
Audio Language: Some digital TV broadcasts provide audio soundtracks in multiple
languages. If you are watching such a program, select Audio Language from the Audio
menu to choose a soundtrack language: English, Français, Español or Português.
Digital Audio Out: The Crystal Series LCD Display can output either two or six channels
of digital audio. Select Dolby Digital if your A/V receiver can decode a Dolby
Digital-encoded, 5.1-channel bitstream. Otherwise, select PCM to have the Crystal Series
LCD Display output PCM-encoded, stereo audio.
TV Speaker: To disable the speakers, select TV Speaker from the Audio menu, set it to
Off and press ENTER. The effect is similar to using the MUTE button, except that the
Crystal Series LCD Display “remembers” this setting if you turn off the display, then turn it
back on.
Audio Delay: Use the Audio Delay control to correct audio/video synchronization issues
with DTV broadcasts. Select from 0 to 40 milliseconds of delay, as needed.
Channel To set up the Crystal Series LCD Display channel tuner, select TV as the source. Then,
select Channel from the Main Menu and press ENTER.
Auto Tuning: To have the Crystal Series LCD Display automatically detect available TV or
CATV channels, select Auto Tuning and press ENTER. Then, select STD and press
ENTER again.
The Crystal Series LCD Display searches all channel frequencies and adds a channel to its
memory when it detects a signal on that channel frequency. (This may take a few
minutes.) If Auto Tuning fails to detect any CATV channels, select HRC or IRC and try
again. (STD, HRC and IRC refer to different sets of frequencies used by cable television
providers. IRC stands for “Incrementally Related Carrier;” HRC stands for “Harmonically
Related Carrier.”)
Add/Erase: If Auto Tuning fails to detect a channel, select Add/Erase from the Channel
menu and press
or to select it. Then, select Add to add it to the channel list. To
erase the currently-selected channel from the available channel list, select Add/Erase from
the Channel menu, then select Erase.
Favorite Channel: You can specify up to five channels as “favorite” channels that can be
accessed by pressing a single button on the remote, instead of manually entering the channel
number. To do this, select Favorite Channel from the Channel menu and press ENTER.
Use the up- or down-arrow button to select the memory location in which you want to
store the favorite channel. Then, use the left- or right-arrow button to specify the channel
number.
To erase a favorite channel selection, press ENTER.
Press EXIT when you have finished programming favorite channels.
To recall a favorite channel, press the FAV CHAN button repeatedly on the remote
control.
Channel
Auto Tuning
Add/Erase
Favorite Channel
➤