Roland TD-20K - Manual (Page 11)

11
PD-125/PD-105
(V-Pad)
fig.15.e
The only difference between the PD-125 and
the PD-105 is the diameter.
* The figure shows the PD-125.
* Do not apply excessive force to the sensor located below the center of the head of the unit. Doing so can interfere with accurate detection,
and may damage it.
* Due to the nature of the materials used in the sensor, changes in room temperature and humid may affect the sensitivity of the sensor.
Use the internal stereo cable to connect to the MDS-20 drum stand. If you use a monaural cable, rim shots cannot be played.
You can play rim shots when the pad is connected to the trigger input shown below.
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power
on all devices before making any connections.
Rim-Shot-Capable Trigger Inputs
2 (SNARE), 3–6 (TOM 1–4), 12–15 (AUX 1–4)
Brush-Sweep-Capable Trigger Inputs
2 (SNARE)
Make sure the snare drum stand you use is designed to firmly hold a 12-inch (PD-125) drum.
Be sure to tighten the stand fixing screw to prevent the noise.
fig.16.e
When mounting the PD-125/105 to a tom stand, verify
the dimension of the rod. (6.3–12.5 mm)
Component (Parts) Names
Setup
Connecting to the Sound Module
Mounting on a Snare Stand
Mounting on a Tom Stand
Hoop (rim)
Lugs
Output jack
Shell
Bracket
Frame
Head
Stand fixing
screw
Tuning bolts
Rod (diameters which can be attached: 6.3–12.5 mm)
tighten loosen
TD-20K_e.book 11 ページ ２００６年１２月７日 木曜日 午前９時２４分