Roland TD-20K - Manual (Page 15)

15
Assemble the TD-20K
Using the built-in connection cables of the MDS-20, connect the pads, cymbals, hi-hat, kick trigger pad, and percussion sound
module.
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power
on all devices before making any connections.
fig.25.e
• The HI-HAT and RIDE cymbal use two cables each.
• After the VH-12 is connected to the TD-20 percussion sound module, the offset must be adjusted .
• Use trigger inputs AUX1-AUX4 when adding new pads.
* Do not pull or stretch the cables too tight.
T1 T2
T3
T4
PD-125
PD-125
PD-125
RD (BOW/BELL)
RDE (BOW/EDGE)
CY-14C CY-14C
CY-14C CY-14C
CY-15R CY-15R
CR1 (BOW/EDGE)
CR2 (BOW/EDGE)
KIK
KD-120
SNR
PD-105 PD-105
TD-20
HH (TRIGGER OUT)
HHC (CTRL OUT)
VH-12 VH-12
KIK SNR T1 T2 T3 T4 HH HHC CR1 CR2 RD RDE AX1 AX2 AX3 AX4
TD-20 Rear Panel * When connecting the cables, please refer to the marking labels that are attached to both ends of the cables.
TD-20K_e.book 15 ページ ２００６年１２月７日 木曜日 午前９時２４分