Radio Shack SYSTEM 440 - Manual (Page 18)

18
Follow these steps to mount the module on a wall.
1. Using the round holes in the
mounting bracket as a tem-
plate, mark the mounting
screw locations on the wall.
2. Drill two holes in the wall at the
marked locations.
3. While holding the bracket
against the wall, thread a
screw through each round hole
in the bracket, then tighten the
screws.
4. Route the cords through the openings in the bracket, then align the
slots on the back of the module with the hooks on the bracket. Gen-
tly push the module down on the bracket to secure it.
To remove the module from the bracket, press up from the bottom of the
module until it snaps off the wall.
Hooks
Mounting Bracket
Holes
43-974.fm Page 18 Monday, August 16, 1999 4:27 PM