Radio Shack 62 (16-632) - Manual (Page 28)

28
SELECTING THE SIGNAL
TO RECORD
You can select the signal to record — from the
IN FROM ANT jack or an audio/video source —
in either of these ways.
• Repeatedly press INPUT until the desired
input source appears — LINE ( LINE 1
or LINE 2 on the Model 62) for an audio/
video source, or a channel number for
broadcast signals.
• Repeatedly press CH s or CH t to set the
VCR to the desired broadcast channel or to
one channel higher than the highest chan-
nel number (or one channel lower than the
lowest channel number) for an audio/video
source.
Note: (Model 62 only) Select LINE 1 for re-
cording signals from the back AUDIO IN 1/VID-
EO IN 1 jacks, or LINE 2 for recording signals
from the front AV2 jacks.
RECEIVING/RECORDING
STEREO/SAP BROADCASTS
(MODEL 62 ONLY)
The Model 62 has three channels for audio re-
cording — two (left and right) stereo channels
on the Hi-Fi track, and one monaural channel
on the standard track.
Press DISP/ENT to display the audio programs
available on the broadcast you are currently
tuned to.
STEREO , SAP , and MONO appear.
Parenthesis appear around each type of audio
signal that is not available. For example, if a
station broadcasts mono (monaural) and SAP
signals,
(STEREO) , SAP , and MONO appear.
The arrow mark on the right of the audio mode
display indicates the current audio mode. To
select the audio mode when the broadcast has
a stereo or SAP signal, press
SAP/Hi-Fi so the
arrow mark points to the desired mode.
IMMEDIATE RECORDING
Recording a Program
as You Watch It
Follow these steps to record a program as you
watch it. If you know how long the program is,
you can set how long the VCR records so it
stops recording automatically.
Note: If you are watching the program on a TV/
monitor that is connected to the VCR’s
AUDIO/
VIDEO OUT jacks, set the TV/monitor to the vid-
eo mode and skip Steps 2 and 3.
1. Turn on the VCR and the TV.
2. Set the TV’s tuner to the same channel as
3-CH-4 on the back of the VCR.
3. Press TV/VCR until VCR appears.
4. Load a blank cassette, or one that you
want to record over, into the VCR.
5. Repeatedly press SPEED on the remote
control until the desired recording speed
(
SP , LP , or EP ) appears.
6. Select the signal to record (see “Selecting
the Signal to Record”).
7. (Model 62 only) Set the audio recording
mode to the desired setting. See “Receiv-
ing/Recording Stereo/SAP Broadcasts
(Model 62 Only”).
8. Press REC/TIME . The VCR starts to record
and the following appears on the TV
screen:
TO SET SPEC I F I C REC T I ME
PLEASE PUSH REC KEY
REC 02
16-549.fm Page 28 Tuesday, July 20, 1999 5:04 PM