Radio Shack 62 (16-632) - Manual (Page 31)

31
To record a broadcast at a specific time
and date, repeatedly press
PLAY or STOP
to select the specific date.
Press FAST-F to store your selection.
9. Repeatedly press PLAY or STOP to select
the start hour. When the correct hour
appears, press
FAST-F . Then repeatedly
press PLAY or STOP to select the minute
and press FAST-F .
10. Repeat Step 9 to set the end time.
11. Repeatedly press PLAY or STOP to select
the channel.
To record from a source connected to the
AUDIO IN 1/VIDEO IN 1 (or AV2 for the
Model 62) jacks, repeatedly press PLAY or
STOP until LINE ( LINE 1 or LINE 2 on
the Model 62) appears.
12. Repeatedly press PLAY or STOP to select
the tape speed ( SP , LP , or EP ).
13. Double-check all the set information.
• If the information is correct, press PROG .
• If an entry is not correct, repeatedly
press FAST-F or REW to move the cursor
to the incorrect entry, enter the correct
information, then press
PROG .
The timer settings appear on the TV
screen. To enter another setting, repeat-
edly press
PLAY or STOP to select another
timer number and repeat Steps 7–13.
14. Press PROG again. TURN VCR OFF FOR
TIMER RECORDING briefly appears.
15. Press POWER to turn off the VCR. TIMER
appears.
Notes:
• Be sure that TIMER appears when you
turn the VCR off. If it does not appear,
check your entries.
• If you load a cassette with its erase-pro-
tection tab removed and set the VCR’s
timer, the VCR ejects the cassette and
flashes TIMER.
• If you set up the VCR to record a cable
broadcast through a cable box, be sure to
leave the cable box turned on and tuned to
the desired station before the broadcast
starts.
• You can manually turn on and operate the
VCR before the set times, but the VCR
starts an automatic timer recording only if
the power is off at the set start time.
Monitoring an Automatic Timer
Recording
1. Turn on the TV and set it to the same chan-
nel as 3-CH-4 on the back of the VCR.
Note: If you are using a TV/monitor that is
connected to the VCR’s
AUDIO/VIDEO OUT
jacks, set the TV/monitor to the video
mode.
2. Press TV/VCR until VCR appears.
Checking/Changing Timers
1. Turn on the TV and set it to the same chan-
nel as 3-CH-4 on the back of the VCR.
Note: If you are using a TV/monitor that is
connected to the VCR’s
AUDIO/VIDEO OUT
jacks, set the TV/monitor to the video
mode.
SELE CT START DATE
DATE START STOP CH
EP
SET : KEY
SELECT : KEY
END : PROG KEY
TODAY
8 SAT --:-- --:-- --
16-549.fm Page 31 Tuesday, July 20, 1999 5:04 PM