Radio Shack 32-2057 - Manual (Page 11)

11
The Basics
Notes:
• Write down the CH setting for each audio source. Then,
when you want to mix that source, you can adjust its
volume to that setting.
• If it was necessary to set CH 1 to maximum to get a reading
of 0 or less on the LED meter, slide CH 1 down to about 8 and
adjust MASTER upward until you get a reading of 0 on both
LED meters.
presetting the microphone
1. Turn on your microphone.
2. Set OFF/ON/TALKOVER to ON.
3. While talking, adjust DJ MIC until you get a signal reading
of up to 0 on both LED meters.
4. Set OFF/ON/TALKOVER to OFF.
MIC — connect a microphone
with an XLR plug here
DJ MIC — adjusts volume of
the microphone connected to
the MIC jack.
OFF/ON/TALKOVER
MASTER —adjusts overall
volume of sources connected
to DJ MIC, CH1, CH2, and CH3.