Riverstone Networks WICT1-12 - Manual (Page 597)

Riverstone Networks RS Switch Router User Guide Release 8.0 28-11
RMON Configuration Displaying RMON Information
The following shows the same
rmon show hosts
command with a filter applied so that only hosts with inpkts greater
than 500 are displayed:
RMON CLI filters can only be used with the following groups:
• Hosts
• Matrix
• Protocol Distribution
• Application Layer Host
• Network Layer Host
• Application Layer Matrix
• Network Layer Matrix
Creating RMON CLI Filters
To create RMON CLI filters, use the following CLI command in Configure mode:
Using RMON CLI Filters
To see and use RMON CLI filters, use the following CLI command in User or Enable mode:
rs# rmon apply cli-filter 4
rs# rmon show hosts et.5.4
RMON I Host Table
Filter: inpkts > 500
Address Port InPkts InOctets OutPkts OutOctets Bcst Mcst
------- ---- ------ -------- ------- --------- ---- ----
00001D:9D8138 et.5.4 1204 80110 941 121129 0 0
01000C:CCCCCC et.5.4 2389 740514 0 0 0 0
0180C2:000000 et.5.4 1540 98560 0 0 0 0
080020:835CAA et.5.4 940 121061 1204 80110 0 0
FFFFFF:FFFFFF et.5.4 1372 285105 0 0
Creates an RMON CLI filter.
rmon set cli-filter
<filter-id> <parameter>
Displays RMON CLI filters.
rmon show cli-filters
Applies a CLI filter on current Telnet or Console session.
rmon apply cli-filters
<filter-id>
Clears the currently-selected CLI filter.
rmon clear cli-filter