Ryobi 2075r - Manual (Page 13)

MAINTENANCE AND REPAIR INSTRUCTIONS
13
Fig. 18
Fig. 19
Fig. 17
5. Repeat the procedure with the second eyelet
and use the same amount of line as specified
in Step 2.
6. Wind the inner reel counterclockwise until
approximately four (4) inches of line remains
outside of the eyelets in the outer spool
(Fig. 17).
7. If winding the line becomes difficult or the line
jams, pull the ends of the line away from the
spool and continue winding the inner reel
counterclockwise (Fig. 18).
1. If you need to remove the Bump Knob to
clean the spool or remove jammed, excess
line, hold the outer spool, and unscrew the
Bump Knob counterclockwise (Fig. 19).
TO INSTALL NEW TRIMMING LINE, IT IS NOT
NECESSARY TO REMOVE THE BUMP KNOB.
Releasing the Inner Reel
If the SpeedSpool does not operate correctly
when bumping the head on the ground, use the
following instructions.
Pull the ends of the line firmly away from the
spool to release the inner reel (Fig. 18). If this
procedure does not release the inner reel, follow
the “Cleaning the SpeedSpool” instructions
below.
Cleaning the SpeedSpool
If the SpeedSpool becomes difficult to wind or
does not operate correctly when bumping the
head on the ground, use the following
instructions.
Fig. 20
2. Remove the Bump Knob, foam seal, spring,
inner reel, and trimming line from the outer
spool (Fig. 20).
3. Remove any debris or grass from the knob,
spring, inner reel, and foam seal. Remove
any existing line from the inner reel before
cleaning. Wash the inner reel with warm
soapy water (Fig. 21).
Bump Knob
Foam Seal
Spring Assembly
Inner Reel
Fig. 21
Inner
Reel