Radio Shack CID-947 - Manual (Page 14)

14 Preparation
Attaching the Mounting Bracket
1. Align the slots on the bottom of the module with the hooks
on the mounting bracket.
2. Gently push the module down on the bracket to secure it.
If you are placing the module on a desk, shelf, or table, pull out
the stand on the back of the bracket until it clicks.
To remove the module from the bracket, press up from the bot-
tom of the module until it snaps off the bracket.
Mounting on a Wall
To mount the module on the wall, you need two screws (not
supplied) with heads larger than the keyhole slots on the back
of the mounting bracket.
1. Using the keyhole slots in the supplied mounting bracket as
a template, mark the mounting screw locations on the wall.
2. Drill a hole in the wall at each marked location.
3. Thread a screw through each hole, letting the head extend
1 /
8
-inch (3.5-mm) from the wall.
43-947.fm Page 14 Thursday, May 25, 2000 11:36 AM