Operation, Important warning warning – RedMax HEZ3001S User Manual

Page 34

Advertising
background image

34

8. Operation

English

The RedMax stick edgers are designed for edging lawn
in gardens, parks, roadsides and so on.
Before starting the engine, take the operating position
and adjust the handle position and the wheel height as
necessary.

ADJUSTING WHEEL HEIGHT
1. Loosen the wing nut and change the wheel height to

obtain desired cutting depth. (OP1)

(1) Deep cut
(2) Shallow cut
(3) Wing nut

2. After adjusting the height, tighten the wing nut

securely.

Tightening Torque: 51~68 in-lbs (6~8 N.m)

• Never adjust wheel height with the engine

running.

STARTING ENGINE

The cutting head will start rotating upon the engine
starts.

1. Rest the unit on a flat, firm place. Keep the cutting

head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.

2. Push the primer pump several times until overflown

fuel flows out in the clear tube. (OP2)

3. Move the choke lever to the closed position. (OP3)
4. Set the ignition switch to the “Start” position. While

pulling the throttle lever, push the throttle set button,
and release the throttle, then the throttle lever is in to
the “Start position”. (OP4)

5. While holding the unit firmly, pull out the starter rope

quickly until engine fires. (OP5)

(1) Choke lever

(2) Close

(3) Open

(4) Ignition switch

(5) Start

(6) Stop

(7) Throttle set button

• Avoid pulling the rope to its end or returning it by

releasing the knob. Such actions can cause starter
failures.

IMPORTANT

WARNING

WARNING

OP2

(1)

(2)

(3)

OP1

(1)

(2)

(3)

OP3

(4)

(5)

(6)

(7)

OP4

Advertising
This manual is related to the following products: